Following the same principle of the hard ground technique, the soft ground process it is quite different. Soft ground is in fact a different wax where the resin is replaced by oil, making it obviously more sensitive and malleable at room temperature.
The first steps prior to drawing, have been to prepare a board with some pieces of cardboard to hold the plate firm once we applied the soft ground and to back the plate with tape, to protect it from corrosion. In this way, once the plate was rolled up with the oily wax, we didn’t have to handle it to much, spoiling the even layer of soft ground.
After that, a piece of tissue paper was placed on top of the plate and secured with tape. This is the surface where the drawing is made with any medium we would normally use for drawing, like pastels, charcoal, pencils and so on.
I used a normal pencil and draw a little platypus, from a picture I found online long ago.
Once finished, I removed the tissue paper from the surface, in this way lifting the soft ground where I made marks, therefore uncovering the metal.
Right after that, I left the plate in the saline sulphate bath for about 10 minutes.
I then washed the plate with a delicate spray, just in case I needed to keep the wax on to etch the plate further.
I checked how the acid worked my marks with the tutor and we decided it was ok to print!
So I cleaned up the plate, inked it and finally pressed it.
I am so impressed with the result, probably because I really didn’t expect it.
I have to admit, I was not so attracted by this technique in the first place, but I definitely changed my mind while having a go at it! I particularly loved the freedom this technique allows in making marks.
I really enjoyed the process and even more the outcome!